Skip to toolbar
Blipvertus multigame Dwarf army

Blipvertus multigame Dwarf army

Supported by (Turn Off)

Shields Pt 2

Tutoring 5
Skill 3
Idea 3
No Comments

The decals or transfers are from Little Big Man Studios however these specific decals are not available from the LBMS site but only through Oathmark. I’m not exactly sure why.

In any event, the LBMS instructions are quite good. My specific suggestion is that as soon as you receive the transfer sheet, open the package and find an inconspicuous corner of the sheet and very carefully peel back the plastic covering, but do not entirely remove it. Put it gently back in place. By doing this you’ll make it easier to remove the plastic later and make it less likely that the transfer will fuse to the plastic. And by putting the plastic back in place you’ll protect the transfer until ready for use.

Cut the transfer out and then carefully the transfer as close as possible to the design. Cut the transfer out and then carefully the transfer as close as possible to the design.
Dry fit the transfer to the shield to make sure it’s the right size.  One annoying fact of the Oathmark dwarves is that there are several different shield sizes. Fortunately the LBMS transfers are made in all the right sizes but you’ll have to marry up the right sized transfer to the shield. Dry fit the transfer to the shield to make sure it’s the right size. One annoying fact of the Oathmark dwarves is that there are several different shield sizes. Fortunately the LBMS transfers are made in all the right sizes but you’ll have to marry up the right sized transfer to the shield.
Once you’re satisfied carefully remove the plastic covering the transfer. The now exposed transfer is sticky and you want to put the sticky size down and in contact with the shield face. Once in place, press down firmly. Once in place, apply water to the transfer paper. Get it thoroughly soaked, then press down firmly again. Then peel off the wet paper.  Once you’re satisfied carefully remove the plastic covering the transfer. The now exposed transfer is sticky and you want to put the sticky size down and in contact with the shield face. Once in place, press down firmly. Once in place, apply water to the transfer paper. Get it thoroughly soaked, then press down firmly again. Then peel off the wet paper.
With the transfer now in place and exposed, use Micro Sol by Micromark if necessary, to help the transfer conform to any raised areas on the shield. Micro Sol essentially softens the transfer film allowing it to conform to contours. With the transfer now in place and exposed, use Micro Sol by Micromark if necessary, to help the transfer conform to any raised areas on the shield. Micro Sol essentially softens the transfer film allowing it to conform to contours.

Leave a Reply

Supported by (Turn Off)