3D printing with janus1004
Printable Scenery - Port Tavern
A Port Tavern from Printable Scenery printed using 0.1mm resolution. Consists of four larger pieces and a few smaller ones, total printing time was about 300h or so. I intend to use it for Blood and Plunder, but I think it should work well for WW2 in Italy/North Africa too.
As can be seen I swapped filament during the printing of this and a bit of warning here. The orange is new “normal” PLA from Prusa (not Prusament) and it is of noticably lower quality compared to the same product bought about 9 months ago (before Prusament). It seems that Prusa is promoting their own product, so I would avoid buying the “normal” PLA from them. It does not have quality enough to motivate the hassle with importing in my mind. Personally, I will be getting Prusament PLA instead, but that comes at a premium.
Print without any cleanup.
Leave a Reply