Skip to toolbar
Project Primingholderthingy

Project Primingholderthingy

Supported by (Turn Off)

Aaaand done.

Tutoring 3
Skill 4
Idea 3
No Comments

So now I have drilled small holes in the bottom middle of my miniature holders, added a little recess and screwed some screws flat in. On top of them I drilled 5mm holes off centre and glued a 5x3mm magnet in. Off centre because the washers I glue under the bases have a hole in the middle so a magnet there would be rather useless 😉

The same sized magnet is plunged in a little recessed hole in my primingholderthingy and glued in flush and centred. So now I can drop my miniature holders in there and they won’t fall off. See attached pictures 😉

Leave a Reply

Supported by (Turn Off)