Skip to toolbar
Fateslayer Kickstarter Models

Fateslayer Kickstarter Models

Supported by (Turn Off)

Assembled models and first painting session

Tutoring 0
Skill 0
Idea 1
No Comments
The huntressThe huntress

The huntress went together ok except for gluing on the axe. It attaches at both wrists and they are very fine joints.

I undercoated zandri dust and then painted the skin with successive layers of bugman’s glowcadian fleshtone, then kislev flesh. The cloth was painted celestra grey and then highlighted ulthuan grey. Her hair was painted warlock purple and highlighted with emperor’s children.

The huntsmanThe huntsman

The huntsman also went together ok except that I needed to use a little greenstuff around his neck where the head didn’t quite go on properly. Also his feet didn’t end up glued to the correct parts of the rocks.

 

The huntsman was painted in the same way as the huntress except his hair was painted naggaroth night and highlighted genestealer purple.

Soul sovereignSoul sovereign

This model has only been assembled and undercoated so far. I’ll probably tackle it last. I think I’ll use it as a test model for my Age of Sigmar Nighthaunt army.

 

Even following the instructions on the Kickstarter page I wasn’t sure where each of the arms and heads were supposed to go. The peg and sockets on the parts also didn’t fit properly so I clipped off the pegs and just had to guess where everything went. I little greenstuff was required where the three heads touched the neck.

MorosMoros

I’ll paint this one after the huntsman and huntress. I’ll try some unusual skin tones to go with the tentacles and mutation.

Leave a Reply

Supported by (Turn Off)