Skip to toolbar
Bandua Infinity Train - Large terrain piece

Bandua Infinity Train - Large terrain piece

Supported by (Turn Off)

Foam Bits Post 1!

Tutoring 5
Skill 4
Idea 0
No Comments

So this is the part of the build I was looking forward to the least. The train has 8 foam pieces that are used to make round sections of the Train’s generators.

I noticed immediately when building the first of these two generator sections (one on both sides of the train) that I made a mistake. I partially built the wall, and realized it gets in the way of installing the foam. Therefore I did not build the wall on the opposite section.

Above you can see the top MDF sections of the generators are built. I also gave them time to dry as the foam puts outward pressure on the circular bit. These caps essentially keep the top end of the foam in a round shape.

The next picture is dry fitting one of the pieces to see how it goes together. Fits rather well without the wall installed.

As you can see here, the wall is angled and thus blocks the bottom slots for the foam a bit. This makes assembly a lot harder. After a bit of tweezer work and no small amount of dexterity I did manage to get them all in. (Was not fun)As you can see here, the wall is angled and thus blocks the bottom slots for the foam a bit. This makes assembly a lot harder. After a bit of tweezer work and no small amount of dexterity I did manage to get them all in. (Was not fun)

Leave a Reply

Supported by (Turn Off)