Ad Victoriam
Print complete
(12) I finished printing all my vertibird’s parts ready to test fit and prep for sanding. First i check for any bit of supports that i may have missed. Second i did repairs on any damage parts (the landing gear in the rear needed to be pinned). Lastly i check how well part fit together (i rather reprint at this time than waste time making part fit).
(13) All look good, Just shy of 100 hour to print at this scale and i think it was total worth it.
(14) Reach my project goal.
Now it time to sand and putty and prep for paint.
Major set back when i got a phone call in the middle of using a heat gun. The heat gun on low setting can remove stringing if you are careful LOL.
Leave a Reply